They sent me a whole list of things to try but also said this: Among other things, a very useful feature is the hot-swap function of storage drives, initially built into the SATA interface. Select the Select utility and press Enter. There are two unpackaged LEDs near each of these connectors see the photo of a connector above. The section contains the following subsections:. In a newer PCMakr04 track test the gap between the controllers is not that large, though Adaptec SA is outperformed by its competitors, while the SiI demonstrates a large gain from using a higher-frequency PCI bus. A tad lower results are demonstrated in the workstation pattern, though Adaptec still retains its leadership.

Uploader: Tular
Date Added: 14 May 2009
File Size: 43.83 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 62455
Price: Free* [*Free Regsitration Required]

Initializing a disk drive that is part of an array might make the array unusable. Adaptec controllers support single-drive volumes that can be used for drives that are not part of a RAID array. I then adwptec setting up two two-drive RAID one arrays. Additional features, like the controller supporting some functions of the enclosure, only amplify the attractiveness of this tandem.

Adaptec Serial ATA RAID 2410SA – storage controller (RAID) – SATA 1.5Gb/s – PCI 64/66 MHz Series

Customer review No Review Yet This is your chance! This leads to me two possible conclusions: The bundle also includes a special 4-wire cable to connect the enclosure to the controller running order indicators on the front panel of the enclosure: We delete comments that violate our policy2410sx we encourage you to read. Select the controller you want, then press Enter.


There are some disadvantages, of course: Perhaps, the main difference of the sole AARSA controller from the same controller in the SA Enclosure Kit is a special 4-pin connector in the latter on the photo on the right.

I installed it in one of our servers and updated the firmware, installed the latest drivers and storage manager. In a situation where you want each phy on a controller to be in a different SAS domain, this setting specifies a unique world-wide name for each phy. Select the disk drive you adapec, then press Enter. This setting is for SAS address conflict resolution only and must otherwise remain at its default value.

When enabledthe system can be booted from a bootable CD. Posted May 17, Instructions for completing tasks are displayed onscreen. When you have finished locating your disk drive, press any key to stop the blinking.

Adaptec SA SATA Raid install w/ Centos – CentOS

From your details, it appears the the PCI bus is your limitation. The event log is cleared of any non-persistent events each time you restart 2410sx computer.

Items that are bought by us when a purchase is made, this generally is for highly expensive items, items with a very slow run rate or speciality items.


Default setting is Yes enabled. The 2410za contains the following subsections:. Phones by Shara Tibken Dec 6, If you modified any settings, you are prompted to save the changes before you exit.

Adaptec 2410sa RAID Controller 4x SATA PCI Top

BioShock Infinite and Metro: Sign in with Google. Would order from them again.

Nevertheless, according to the averaged results of reading, writing, and copying files with single weightthe Adaptec controller is a tad slower than its competitors, while the SiI is nearly as fast as the 3ware Escalade Each individual bay is equipped with a flap handle for removal and a latch hard drives cannot be locked adapte a key.

When enabled, the controller constantly verifies a redundant array. A tad lower results are demonstrated in the workstation pattern, though Adaptec still retains its leadership.

Can anyone offer any advice? Adaptef default setting is Autowhich allows the SAS card to adjust the data transfer rate as required. Each NTFS partition occupied half of the entire disk capacity that is the second partition started exactly from the second half of the disk.